LeeMarmara

I have built the DRAWCLI sample and used Insert Object to add an excel spreadsheet. When the object is active (i.e. I have double clicked on it) and I scroll down it doesn't display properly. I get hatched drawing and the bottom portion is shifted to the right. As I scroll to the bottom it then corrects itself.

The same problem is then seen when scrolling up.

How do I fix this



Re: Visual C++ General DRAWCLI Problem

Bite Qiu - MSFT

hello

Re: DRAWCLI Problem

Such questions are less likely to be answered in this forum, see the scope pf this forum. A potential good place could be found here:http://msdn.microsoft.com/newsgroups. I am going to mark this thread as answered since it is off topic, If you cannot find a more appropriate place or still believe this forum is the best fit for your question, please feel free to unmark this thread and we will look into it again.

thanks for understanding

rico






Re: Visual C++ General DRAWCLI Problem

LeeMarmara

Sorry.  I thought that as it was a question about a sample program that this was the place.

I have looked for a relevant forum and the one I find has very few answers over the last couple of months and I need an answer asap.





Re: Visual C++ General DRAWCLI Problem

Bite Qiu - MSFT

An alternative to forum is newsgroup. As mentioned in the scope, for win32 programming, a certain newsgroup is more appropriate, I would go for win32.programmer.ole and vc.mfc to have a try. But anyway, its up to you. If your problem get solved in the newsgroup, also remember to close this thread by mark an useful post as answer. thanks.

have a nice day

rico